Insight category · 40 articles · Page 3 of 5
System architecture, sensing, interfaces and acceptance methods.
Article archive
Showing 19–27 of 40
GNSS deformation monitoring system design and acceptance
Design a GNSS monitoring system with stable references, observation-quality controls, displacement uncertainty, health states, alarms, and acceptance tests.
Underwater bridge inspection with ROV, sonar, and diver handoffs
Plan underwater bridge inspection with traceable substructure coverage, ROV video, imaging sonar, uncertainty controls, and defined diver handoffs.
Bridge monitoring system design and acceptance
Design a bridge monitoring system by linking engineering decisions to measured quantities, sensor baselines, environmental compensation and response workflows.
Drone bridge inspection planning and evidence
Plan drone bridge inspection as a supplementary evidence method with component coverage, repeatable imagery, GPS-poor flight controls and physical follow-up.
Tailings Dam Monitoring: Connect Instruments to Failure Modes
Design tailings dam monitoring around failure modes, pore pressure, deformation, water balance, independent review and trigger-action responsibilities.
ONVIF Profile T and M: Specify Video, Metadata and Migration
Specify ONVIF Profile T and M by device and client functions, firmware conformance, secure transport, event mapping and a tested Profile S migration path.
Traffic Queue Detection: Measure the Back of the Queue, Not Just Flow
Design traffic queue detection around lane-level queue tails, sensor coverage, warning latency, degraded states and field evidence from changing work zones.
Slope monitoring radar measurement and site acceptance
Accept slope monitoring radar by testing line-of-sight geometry, reference stability, environmental artifacts, corroboration, faults, and recovery.
BVLOS drone communications and C2 resilience
Design resilient BVLOS drone communications by separating C2 and payload traffic, modeling route service, securing backup paths, and testing lost-link behavior.
Use an article to define the decision, then share the mission, site and destination for a project-specific review.
Start a technical inquiry